■Assembling
Procedures
·Mount
fixed support side on ball screw
*Don't disassemble the parts of support.
*Ball screw should be combinate with the same
diameter of support.
·After inserting the shafting into the finxed support side
tighten the support with lock nut.In addition hold it tighter.
Using the set piece and Hexagon socket screw.
*Please
contact with us if you have any further questions.
·Put the ball screw into simple support side and fixed it
by C type retaining ring.
 |
■Mounting
the table on the ball screw nut and mounting the support unit
on the base
·Mount
the ball screw nut on the table.If a bracket is used,place
the ball screw nut into the bracket.Temporarily tighten the
ball sctew nut.
·Temporarily mounts the fixed-end support on the base. Move
the table toward the support side, and center the ball screw
so the table is balanced.To adjust, one of the following methids
can be chosen.
·Execute the adjustment with reference to the square or round
support unit. Mark sure there is a clearance between the table
bore and the outer circumference of the nut.
·Use shim plates to center the square support unit with the
center of the table.Create a clearance between the outer circumference
of the round support unit and table bore.
■Accuracy
·Move
the table toward support-end housing side.Center the bal
screw.Move the table to both directions to make sure it
be balanced,then temporarily tighten the housing on the
base.
·Use
tow dial indicators;one to check the run-out error an end
of the ball screw shaft and the other to check the axial
clearance.Finally,tighten the nut,fixed-end support unit,and
supported-end housing firmly.
■Connecting
to the motor
·Fix
the motor to the machine.
·Use the coupling to connect the motor with the ball screw.
·Execute
|
